IX - 9
Maintenance
9.3.3 Maintenance at specified intervals
oil change
check
adjust
bleed
tighten
after initial 8 operating hours wheels, wheel nuts x
and after every wheel changel
after extended PTO shaft slip clutch x
downtimes (friction clutch only)
after the first 500 bales, screws from the
then every 3000 bales, floor conveyor x
but at least once a year
at the beginning of the season chain tension:
(after approx. 5 bales) floor conveyor xx
floor conveyor drive xx
pick-up drive xx
chain tension:
roller drive xx
pick-up drive xx
after first time use
(approx. 30 - 50 operating hours)
then annually after
every season
gearbox x
after the Floor conveyor tension xx
first operations, F 125/F 125 XC
then after every 1000 bales
Intervals Machine
component
check
refer to
cap. Main-
tenance
To Next Page
Loading...
