II - 4
Safety
7. Liquids escaping under high pressure (hydraulic
oil) can penetrate the skin and cause serious
injury! Seek medical help immediately should
injuries occur! Risk of infection!
8. Before working on the hydraulic system, lower
the implement, depressurize the system and
switch off the engine!
2.2.8Tyres
1. When working on the tyres, make sure that the
implement has safely lowered and secured
against rolling (wheel chocks).
2. Installing wheels and tyres requires adequate
knowledge and suitable tools!
3. Repair work on the tyres and wheels should be
done by specially trained personnel using
appropriate installation tools only!
4. Check tyre pressure regularly! Inflate the tyres
to the recommended pressures!
2.2.9Maintenance
1. Always make certain that the drive and the
engine are switched off before doing any repairs,
maintenance or cleaning!
- Remove the ignition key! Secure the flywheel
with the parking brake.
2. Regularly check that nuts and bolts are properly
seated and tighten if necessary!
3. When doing maintenance work to a raised
implement, always use suitable means to secure
it against falling.
4. When replacing working tools with cutting edges,
use suitable tools and gloves!
5. Dispose of oils, greases and filters according
to regulations!
6. Always disconnect the power supply before
working on the electrical system!
7. If protective devices and guards are subject to
wear, check them regularly and replace them in
good time!
8. When doing electrical welding on the
tractor and attached implements, disconnect the
alternator and battery cables!
9. Replacement parts must at least comply with the
technical requirements set by the manufacturer
of the implements!
This is ensured by using genuine KRONE
replacement parts!
10. Only use nitrogen for filling pneumatic
accumulators - Risk of explosion!
2.2.10 Unauthorised Modifications and
Spare Parts Production
Modifications to the machine are permitted only with
the prior approval of the manufacturer. Genuine
replacement parts and accessories authorized by the
manufacturer ensure safe use. Use of other parts
may void liability for damage which results.
2.2.11 Prohibited Modes of Operation
The operational safety of the machine is guaranteed
only if it is used for its intended purpose in
accordance with the General Aspects chapter of the
operating instructions. The limit values listed in the
data charts should not be exceeded under any
circumstances.
To Next Page
Loading...
