A - 1
Appendix
A1 Commissioning
A1.1 Preparing for Commissioning
Due to transport considerations, the PTO shaft and straw trap are not attached to the round baler at delivery.
The round baler needs to be fully assembled prior to commissioning and adjusted to the type of tractor used.
The following parts are packed separately at delivery. The words in parentheses indicate) the storage location
on the machine during transport.
1 bale ejector (under the machine)
2 Spacer (VP 180) (twine box)
3 small parts (twine box)
6 eye bolts (twine box)
7 springs (twine box)
8 springs with clamp bolts (twine box)
9 rail (twine box)
10 screw (twine box)
11 nuts (twine box)
12 safety foil (twine box)
13 spray paint can (twine box)
14 PTO shaft (bale chamber)
15 PTO shaft support bracket (twine box)
16 hose and cable retainer (bale chamber)
17 fasteners (twine box)
18 PTO shaft holder (twine box)
19 feed slats (twine box)
20 linkage (twine box)
21 Ring spanner 13 (not shown) (twine box)
22 Support for control unit (twine box)
23 Control unit (twine box)
24 Electrical power supply on tractor (twine box)
25 Extension cable (not shown) (twine box)
26 Guard cup (twine box)
COM00004_2
1
20
19
17
18
O
K
e
s
c
2
22
23
24
26
To Next Page
Loading...
