ISOBUS-operation
B - 2
1.1 Attaching the ISOBUS terminal
3
4
5
7
6
1
2
Fig. 1
CAUTION!
Failure of control unit.
When attaching the control unit, take care that the connection cables are not stretched and cannot
come in contact with the tractor wheels.
1.1.1 Connection terminal to tractor
Note
For further details on the attachment consult the operating instructions of the ISOBUS terminal
manufacturer.
1.1.2 Connection tractor to machine
• Connect ISO-plug (3) (9-pole) of cable set (1) with outer ISO-socket (2) (9-pole) on tractor side
• Connect plug (4) (7-pole) of cable set (1) with socket (5) (7-pole) of the machine
• Connect plug (6) (2-pole) of cable set (1) with socket (7) (2-pole) of the machine
1.2 Differing functions to KRONE ISOBUS terminal CCI
Via the accessory unit, the ISO control unit will provide information and control functions to the display
of the ISO terminal. Operation with an ISO terminal is analogue to the KRONE ISOBUS terminal CCI.
Prior to start-up, refer to the operating instructions for the method of operation of the KRONE ISOBUS
terminal CCI.
A fundamental difference to the KRONE ISOBUS terminal CCI is the arrangement of the softkeys,
which are determined by the selected ISO terminal.
Only the functions that differ from the KRONE ISOBUS terminal CCI are described in the following.
Note
The values for “Bale size (Comprima V150/180)” and “Bale density (Comprima F125/155)”
which are set by the scroll wheel in the basic screen on the KRONE ISOBUS terminal CCI, are
set on the ISO terminal with the selection key predetermined by the ISO terminal (refer to the
operating instructions of the ISO terminal manufacturer).
To Next Page
Loading...
