V - 2
Basic Settings and Operation
5.2.2 Bearing Pressure Relief of the Pick-
up
In order to be able to pass over unevenness better, the
pick-up is supported by means of two springs.
The springs can be set by means of the ring bolt (1). Both
springs should be set equally.
The default setting is dimension a:
• left 150 mm,
• right 45 mm
Load on the guide wheels must be
sufficiently relieved.
For extreme soil conditions, regulate the raking height
of the pick-up with the chains (2) (right and left-hand
side of the machine).
To do this:
• Raise the pick-up.
• Move the guide wheels (3) up.
• Set the desired raking height by suspending the chain
(2) around the pick-up.
• Make the adjustment on both sides.
When used in straw, the pick-up should be
set as high off the ground as possible. Use
the chain (2) to adjust the pick-up guide
wheels so they do not touch the ground.
If the pick-up is hooked in higher, the
height of the drawbar must be adjusted (see
Appendix „Changing the Drawbar Height“).
RPN00023_3
1
a
2
To Next Page
Loading...
