V - 15
Basic Settings and Operation
The starting end of the netting roll should
point towards the machine and be drawn
from the top down.
• Raise the lever (2).
• Swing the brake disc (1) and the netting roll mounting
shaft (3) forwards.
• Detach the brake disc (1).
• Slide the netting roll onto the netting roll mounting
shaft (3) and the retainer (4).
5.8.4 Inserting the Netting Roll
• Slide the brake disc (1) and cardboard tube clamp (2)
counterclockwise into the cardboard tube and then onto
the netting roll mounting shaft as far as possible.
Once installed, the netting roll can be aligned to the right
and left in the centre to the machine using the mounting
lever (2).
To pull the net, release the brake. To do this press lever (1)
downwards.
Place the net brake buttons (3) below the netting roll.
Attention!- Contamination of tying twine
as well as the tying mechanism by oil and
grease
Effect: Damages to the machine and
problems with unrolling of the tying twine
• Twine, twine tensioner and eyes must
not be contaminated with oil or
grease.
• Those parts of the tying device the
tying twine or net will rum through,
must not be contaminated with oil or
grease.
To Next Page
Loading...
