V - 16
Basic Settings and Operation
• Guide the net (11) over the deflection shaft (8) under
the net compensation (3).
• Place the net (11) further over the spreading bracket
(12) and under the guide roller (13) round, over the
retaining plate (4) and guide it under the synthetic
cloth (10)
To increase net tension (net extends
further outward), the net can also be laid
under the cross tube (15).
The net must be stretched with no
problems when doing this.The net must be
approx. 200 mm above the retaining plate
(4).
• Swing the netting roll mounting shaft back into its
support.
After the net wrap is threaded in, it must
be drawn apart to a width of about 500 mm
to ensure that the feed roller drivers can
receive the net wrap neatly.
5.8.4.1 Feed the net
• Before threading in the net, press the blade bar (1)
back manually until the ratchet mechanism (2)
engages.
Risk of injury on the blade in the blade
bar!
• Wear protective gloves when working
on the blade bar and when threading
in and removing the net!
1
COM00200_1
52
Attention!- Contamination of tying twine
as well as the tying mechanism by oil and
grease
Effect: Damages to the machine and
problems with unrolling of the tying twine
• Twine, twine tensioner and eyes must
not be contaminated with oil or
grease.
• Those parts of the tying device the
tying twine or net will rum through,
must not be contaminated with oil or
grease.
11
13
8
15
3
10
4
12
RPN00008_7
ca.200 mm
To Next Page
Loading...
