Krone Comprima F 155 XC - ISOBUS Short Cut Button

KRONE ISOBUS-Terminal CCI 100
VI - 3
6.2 ISOBUS short cut button
DANGER! – risk of injury by running machine!
Your machine supports the ISOBUS short cut button.
• By actuation of the ISOBUS short cut button (1) the machine functions are switched off in order to
be able to initiate a secure condition of the machine in hazardous situations. Process oriented
procedures perform to the end. Therefore, machine parts continue to run after actuating the
ISOBUS short cut button. This can lead to injuries
• The ISOBUS short cut button does in no case interfere with tractor functions, i.e. neither universal
shaft functions nor hydraulic functions will be affected in any way! Therefore, the machine can
continue to run after actuating the ISOBUS short cut button. This can lead to injuries
When actuating the ISOBUS short cut button (1) of the terminal which is of the pushbutton design, a
stop command is sent onto the ISOBUS. This command will be evaluated by your connected ISOBUS-
machine, in order to initiate the accordant automatic actions in hazardous situations if necessary.
If the ISOBUS short cut button is actuated, the accordant alarm mask will be shown in the display:
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
ESC
CC000070
ISB
1
Fig.3
The functions listed in the following are blocked by the job computer on the machine side.
• Net tying