KRONE ISOBUS-Terminal CCI 100
VI - 13
6.3.1 Setting the target bale diameter
80
120
160
126 cm
2
100
125 cm
140
1
Fig.13
Display bale diameter
The value (1) under the bar display and the height of the bar (1) show the current target bale diameter
in cm.
The value (2) above the bar display (2) shows the set target bale diameter in cm.
The bale diameter is given by the user in basic screen.
• You can use the scroll wheel to select the desired value (the selection box is highlighted in color)
• Pressing the scroll wheel allows you to jump to the selection box (the selection box is highlighted
in color)
• Turning the scroll wheel increases or reduces the value
• Pressing the scroll wheel causes the setting to be applied and returns you from the selection box
To Next Page
Loading...
