KRONE ISOBUS-Terminal CCI 100
VI - 21
Setting and saving the sensitivity of the direction display (V150/V180)
Fig.21
The higher the sensitivity of direction display is set, the stronger the motion indication in the form of
arrows .
The bar display shows the time set (3 seconds in the picture) until the arrow starts flashing as well as
the sounding of the acoustic alarm signal.
• Set the sensitivity with the function key or , the symbol in the top line goes out
• Press the function key . The set sensitivity is saved and the symbol appears in the upper
line
• Pressing the function key closes the called up menu
• Pressing the function key and holding it down brings up the basic screen
In case an irregular filling of the bale chamber is determined, an arrow appears in the basic screen
after 4 seconds, pointing in the according direction.
Should no regular filling be achieved after another while, the displayed arrow will start flashing and an
acoustic alarm signal for irregular filling sounds. This time can be set between 1 and 5 seconds via
this point of menu. The acoustic alarm signal will be deactivated by setting 0 seconds.
Note
If an even filling is reached, all signals expire.
To Next Page
Loading...
