Operation
126
Pos: 48.20 /Ab kürzungen /Abkürz ungen sprac hneutral/Rundb allenpressen/Co mprima F @ 256 \mod_1397 714206905_0.d ocx @ 196264 2 @ @ 1
Comprima F
Pos: 48.21 /BA/Be dienung /Ru ndballenpress e/Ballenkam mer befüllenHinweise Ballenka mmer befüllen CF @ 66\mod_1 302514167499_7 8.docx @ 61 6925 @ @ 1
Note
The binding process should be started at the latest when the baling pressure indicators reach
the red range (the buzzer sounds if the comfort electronic system is fitted).
Note
To prevent overload on the machine when handling certain types of crop (e.g. wet silage), the
binding process should already be started at an earlier point.
Permanent overload of the machine can drastically reduce the service life.
Pos: 48.22 /Übersc hriften/Überschrif ten 3/A-E/D /Druck auf di e Seitenwände d er Ballenka mmer verringern @ 66\mod_13 02510664857 _78.docx @ 61 6669 @ 3 @ 1
11.3.1 Reducing the Pressure on the Side Walls of the Bale Chamber
Pos: 48.23 /BA/Be dienung /Ru ndballenpresse/Pr essdruck einstelle nDruck verri ngern @ 66\ mod_130251 0588984_78.doc x @ 616567 @ @ 1
For very critical forage and extremely hard bales, the bales can be given additional protection
against turning as follows:
• In order to reduce the pressure on the side walls there should not be extreme driving to the
right/left
• Reduce the number of the outer cutting blades or turn off the cutting system or remove the
cutters
Pos: 48.24 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
