Krone Comprima F 155 XC - 12.10.1 Adjusting the distance between the front and rear net roller

Settings
196
Pos: 50.22 /Übersc hriften/Zwisch enüberschrifte n/A-E/Bei Ne tzmotor in unter er Stellung @ 346\mod_143 4622053077_78 .docx @ 2609 670 @ @ 1
With net motor in lower position
Pos: 50.23 /BA/Be dienung /Ru ndballenpresse/G arnbindung C omprima/Gar nbremse lösen einstellen_Netz motor in unterer Stellung_Garn_C omprima_Te xt @ 346\ mod_14346262768 19_78.docx @ 2609697 @ @ 1
• Move the clamping arm (5) all the way downwards.
In this position
- the tension spring (3) must be tensioned,
- the twine brake must be inactive.
• To check whether the twine brake is active, pull on the twines.
• If the brake is active in this clamping arm position, adjust the length of the wire rope (6).
Pos: 50.24 /BA/Ei nstellungen/Ru ndballenpresse/Bi ndung/akti ve Netzbindung K ollision Netz walzen @ 345 \mod_1434369 497150_78.doc x @ 2607161 @ 3 @ 1
12.10.1 Adjusting the distance between the front and rear net roller
2
EBA00013
1
2
Fig.
166
The distance between the front and rear net roller should be around 1 mm.
Note
When adjusting, make sure that the sheet (1) and the net rollers (2) do not collide.
Pos: 50.25 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1