Krone Comprima F 155 XC - 12.11 Setting the Twine Brake

Settings
197
Pos: 50.26 /Übersc hriften/Überschrif ten 2/F-J /G/Garnbrems e einstellen @ 1 27\mod_1346 138729566_78.d ocx @ 114716 4 @ 2 @ 1
12.11 Setting the Twine Brake
Pos: 50.27 /Übersc hriften/Zwisch enüberschrifte n/A-E/Bei A usführung Garn- und Netzbindu ng @ 335\mo d_142961846475 0_78.docx @ 2552971 @ @ 1
With twine tying and net tying version
Pos: 50.28 /BA/Be dienung /Ru ndballenpresse/G arnbindung Co mprima/Garnbr emse einstellen _Bild_Compri ma @ 343\ mod_1433165708 305_78.doc x @ 2595482 @ @ 1
3
2
1
Fig.
167
Pos: 50.29 /BA/Be dienung /Ru ndballenpresse/G arnbindung Co mprima/Garnbr emse einstellen _Text_Comprim a @ 343\m od_143316 5675551_78.doc x @ 2595451 @ @ 1
The twine brake (1) is located in the twine box. The setting screws (2) hold the tying twine under
tension. The tying twine must always be held under tension to ensure that it can be cut off
properly. At the same time, however, the tying twine must not be tightened too much, so that it
can pass easily through the rubber roller when starting.
Different types of tying twine may have different friction properties. If the type of tying twine is
changed, readjust the twine brake:
• Turn the setting screws (2) clockwise or anticlockwise.
Direction of rotation of
setting screws (2)
Pretension of compression
springs (3)
Brake force of twine
brake (1)
Clockwise rotation
Higher
Higher
Anticlockwise rotation
Lower
Lower
It is possible that the compression springs (3) will need to be adjusted differently so that the cut
of twine ends have the same length.
Pos: 50.30 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0 .docx @ 4165 @ @ 1