Krone Comprima F 155 XC - Page 245

Maintenance
245
Pos: 52.135.8 / BA/Einstellung en/Schneidwer k/Messerschalt welle 0-Stellung_C omprima alle @ 363\mod_ 144007548236 3_78.docx @ 2 676340 @ @ 1
Moving blade control shafts (A/B) mechanically into zero setting of blades ( (-) position)
+
+
B
A
RPN00020_3
A
B
Fig.
212
• Turn the blade control shafts back until the blades protrude somewhat into the cutting
channel and can be grasped easier.
Pos: 52.135.9 /Ü berschriften/Z wischenüberschrift en/A-E/Bei Ausführung H ydraulische Messerg ruppensc haltung @ 514\m od_150366357 9390_78.docx @ 3533118 @ @ 1
For the "Hydraulic blade group control system" version
Pos: 52.135.10 /B A/Einstellung en/Schneid werk/Messer wechsel n_hydr Mess ergruppensch altung_alle Compri ma @ 514\ mod_150366 3680086_78.doc x @ 3533149 @ @ 1
• At the terminal in the working screen, select , ,
or .
The keys of the hydraulic blade group control system are displayed on the side.
• To select the maintenance position, press the key.
• Confirm the prompt shown in the display.
• Use the control unit in the tractor to lower the blades.
• Use the control unit in the tractor to raise the blades.
• Use the control unit in the tractor to lower the blades again.
Pos: 52.135.11 /B A/Einstellung en/Schneid werk/Messerschalt welle entriegel n_Comprima alle @ 388\mod_ 14453472101 51_78.docx @ 2777967 @ @ 1
Unlocking the blade control shaft
RPN00015_2
1
I
II
Fig.
213
• Pull handle (1) out of position I and allow it to engage in position II.
Note
The provided key can also be used to lock or unlock the blade control shaft.
Pos: 52.135.12 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1