Krone Comprima F 155 XC - Page 81

Commissioning
81
Pos: 40.29 /BA/Ers tinbetriebna hme/Rundballe npresse/Deichsel höheDeichselh öhe einstelle n CF_CV @ 6 6\mod_1302004 633503_78.doc x @ 593369 @ @ 1
1
1
5
2
5
5
4
3
RPN00063
Fig.
51
Note
Before starting the adjustment set the machine on the parking support and uncouple the tractor.
Adjusting the height of the drawbar:
• Loosen the safety nuts (3) until the drawbar (1) can be turned in the lock washer
connection.
• Adjust the drawbar (1) to the height of the tractor hitch.
To adjust the height of the hitch to the height of the tractor hitch (make setting on both
sides):
• Loosen the screw joint (4).
• Align towing ring (2) horizontal (parallel with the ground).
• Tighten the screw connections (3) and (4) to the appropriate torque.
Note
The lock washers (5) must intermesh.
Retighten the screw connections after 10 operating hours!
Pos: 40.30 /BA/ Wartung/Hinweis Anziehdrehmo mente beachte n (siehe Kapit el Wartung „Anzie hdrehmomente“). @ 326\m od_142597730 5778_78.docx @ 2502836 @ @ 1
Note
Observe tightening torques (refer to chapter Maintenance “Tightening Torques”).
Pos: 40.31 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1