Krone Comprima F 155 XC - 8.1.4 Operational Readiness

KRONE Operation Unit Alpha
92
Pos: 42.14 /Übersc hriften/Überschrif ten 3/A-E/ B/Betriebsber eitschaft @ 64\ mod_1300174 903968_78.docx @ 580838 @ 3 @ 1
8.1.4 Operational Readiness
Pos: 42.15 /WHB/ Elektrik/Rundballe npresse/Alph a (Medium)/B etriebsbereitsch aft @ 82\ mod_1317026811 213_78.doc x @ 724690 @ @ 1
Switching ON
AB CD EF GH
2
3
6
7
8
10
RPM00002
Fig.
65
1. Actuate key.
A brief self-test follows provided the electrical power supply has been properly connected.
– All pilot lamps light up briefly
– A horn is sounded
– All pilot lamps disappear
The following pilot lamps light up after a short time:
• Pilot lamp (1) lights up
• Pilot lamp (7) lights up
• Pilot lamp (4) lights up (with preselected net wrapping) or pilot lamp (5) lights up (with
preselected net wrapping)
• Pilot lamp (9) lights up
The control unit is now ready for operation.
Note
After the control unit is switched on, the manual tying mode is always activated first and the
pick-up is preselected. At the same time, the preset Automatic Blocking Time (see Chapter
entitled “Automatic Blocking Time Setting”) runs programme internally. The horn for “Bale
Chamber Full” is not activated during the automatic blocking time.
Pos: 42.16 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1