Krone EASYCOLLECT 9000 - Checking the Oil Level and Changing the Oil in the Transfer Gearbox (Right;Left; Checking the Oil Level and Changing the Oil in the Collector Gearbox (Right;Left

IV - 4
Maintenance
4.3.3 Checking the oil level and changing
the oil in the transfer gearbox (right/
left)
Perform oil level checks and oil change
while the maize header is in its working
position!
Checking the oil level
• Unscrew the oil level control screw (2) on the
transfer gearbox (1).
• The oil level must reach up to the control hole. If
necessary, add more oil through the control hole.
• Screw in the oil level control screw (2) again.
Changing the oil
• Remove the gear skid (4) by loosening the screws
(5).
• Unscrew the oil drain screw (3) on the transfer
gearbox (1). Collect the oil in a suitable container.
• Screw on the oil drain screw (3) again.
• Unscrew the oil level control screw (2) on the
transfer gearbox (1).
• Add oil (for filling quantity and type of oil, see
Chapter 4.3.1)
• Screw in the oil level control screw (2) again.
• Mount the gear skid (4).
Dispose of old oil properly.
4.3.4 Checking the oil level and changing
the oil in the collector gearbox
(right/left)
Check the oil level in the horizontal
position of the maize header in
transport position!
Checking the oil level
• Unscrew the oil level control screw (2) on the col-
lector gearbox (1).
• The oil level must reach up to the control hole. If
necessary, add more oil through the control hole.
• Screw in the oil level control screw (2) again.
1
2
EC07600
5
5
3
EC200340
4
1
2
1
EC200345