IV - 5
Maintenance
Changing the oil
• Swing the maize header into its working position.
• Unscrew the oil level control screw (2) on the
collector gearbox (1) . Collect the oil in a suitable
container.
• Screw in the oil level control screw (2) again.
• Swing the maize header into its transport position.
• Unscrew the oil level control screw (2) on the
collector gearbox (1).
• Add oil (for filling quantity and type of oil, see
Chapter 4.3.1)
• Screw in the oil level control screw (2) again.
Dispose of old oil properly.
4.3.5 Checking the oil level and changing
the oil in the angular gearbox (right/
left)
Perform oil level checks and oil
changes while the maize header is
horizontal in its working position!
Checking the oil level
• Unscrew the oil level control screw (2) on the
angular gearbox (1).
• The oil level must reach up to the control hole. If
necessary, add more oil through the control hole.
• Screw in the oil level control screw (2) again.
Changing the oil
• Getriebekufe (4) durch Lösen der Schraub-
verbindungen (5) demontieren.
• Unscrew the oil drain screw (3) on the angular
gearbox (1). Collect the oil in a suitable container.
• Screw on the oil drain screw (3) again.
• Unscrew the oil level control screw (2) on the
angular gearbox (1)
• Add oil (for filling quantity and type of oil, see
Chapter 4.3.1)
• Screw in the oil level control screw (2) again.
• Mount the gear skid (4).
Dispose of old oil properly.
To Next Page
Loading...
