Krone EASYCOLLECT 9000 - Scraper (Right; Left; Adjusting the Scraper

IV - 9
Maintenance
4.6 Scraper (right / left)
The distance between the back of the
collector (2) and the scraper (1) must
not exceed the dimension «a = 3 mm».
4.6.1 Adjusting the scraper
• Loosen the screws (3) a little and press the scraper
(1) against the back of the collector (2). Distance
“a = 1 - 3 mm”.
EC100664
X
y
a+4
a
b
1
5
Setting of the gaps (b):
• The scrapers (1) must be aligned parallel to the
collector fingers (4) in the area marked «X». The
scrapers (1) must be extended back conically in the
area marked «Y» (a+4)
If necessary, align the cover (5) as well
by loosening the screws (6).
2
3
EC200420
a
1
1
4
6
• Tighten the screw connections (3).