Krone EASYCOLLECT 9000 - Tips; Adjusting the Side Tips (Right; Left; Adjusting the Central Tip; Replacing Tips

IV - 10
Maintenance
4.7 Tips
The lower edges of the side tips (1
right/ 1 left) should be at the same
height as the lower edges of the tips
(2). The lower edges of the central
tip (3) should be about x = 30-50
mm lower than the lower edges of
the other tips (a = freely selectable
distance to the ground).
If necessary correct the height
adjustment of the side or central
tips.
4.7.1 Adjusting the side tips (right / left)
• Loosen the screws (2) a little.
• Shift the adjusting plate (3) until the bottom edge of
the side tip (1) is at the height of the bottom edges
of the tips.
• Tighten the screw connections (2).
4.7.2 Adjusting the central tip
• Loosen the screws (2) a little.
• Adjust the central tip (1) so that the bottom edge is
approx. x = 30-50 mm below the bottom edges of
the tips.
• Tighten the screw connections (2).
4.7.3 Replacing tips
• Unscrew the cheese head screws (2) on both sides
of the tip (1) and remove the tip (1).
• Remove the bearing rings (3) from the tip (1) and
insert them in the new tip.
• Fit the new tip (1) with the cheese head screws (2).
1
2
3
EC200430
a
a-x
a
2
EC200440
1
1
2
3
EC200450
1
EC200460
2
3