Krone EasyCut 2801 CV - Checking the Oil Level; Oil Change

Special equipment
103
Pos: 39.34 /BA/Sonder ausstatung/EasyCu t / AM Mähwerke/Querför derer/Hydraulik Ölst andskontrolle Bi ld EC 2800/2801 3200/3201 3210/ 4013 @ 39\mod_12680422 89691_78.docx @ 357642 @ @ 1
Figure 69
Pos: 39.35 /Übersc hriften/Überschri ften 3/K-O/Ölkontrol le @ 0\mod_119702190819 0_78.docx @ 16120 @ 3 @ 1
14.9.3 Checking the oil level
Pos: 39.36 /BA/Sonder ausstatung/EasyCu t / AM Mähwerke/Querförder er/Hydraulik- Ölstandskontrolle @ 10\mod_1222335584255_7 8.docx @ 140585 @ @ 1
Check the hydraulic oil level after every 10 operating hours of the cross conveyor.
To do this:
• Lower the machine and switch off the engine.
• Unscrew and remove the ventilation filter (2) (with measuring rod).
• • Use a lint-free cloth to clean the ventilation filter (2) and insert it again completely.
• Pull out the ventilation filter (2) again.
• The oil level must lie between the min. and max. mark.
• Top off with hydraulic oil if necessary.
• Screw in and tighten the ventilation filter (2).
Pos: 39.37 /Übersc hriften/Überschri ften 3/K-O/Ölwechsel @ 0\m od_1197021941955_7 8.docx @ 16139 @ 3 @ 1
14.9.4 Oil change
Pos: 39.38 /BA/Sonder ausstatung/EasyCu t / AM Mähwerke/Querförder er/Hydraulik- Ölwechsel @ 10\mod_122233 5966973_78.doc x @ 140673 @ @ 1
Change the hydraulic oil every 500 hours (but at least once a year).
• Unscrew and remove the ventilation filter (2) (with measuring rod).
• Screw out the oil drain plug (3).
• Collect the used oil in a suitable drip pan.
• Screw in the oil drain plug (3).
• Top up oil (2) (the oil level must lie between the min. and max. mark).
• Screw in and tighten the ventilation filter (2).
Pos: 39.39 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1