Safety
16
Pos: 11.6.16 /BA/S icherheit/Wartung/ Wartung Mäher mit Gasspeic her+ Auswechseln von Ar beitswerkzeugen @ 0\mod_1 195647075607_78. docx @ 1442 @ 2 @ 1
4.8 Maintenance
1 Always make certain that the drive and the engine are switched off before doing any
repairs, maintenance or cleaning! - Remove the ignition key!
2 Regularly check that nuts and bolts are properly seated and tighten if necessary!
3 When carrying out maintenance work on a raised mowing unit, always use suitable means
to secure it against falling.
4 When replacing working tools with cutting edges, use suitable tools and gloves!
5 Oils, greases and filters must be disposed of correctly!
6 Always disconnect the power supply before working on the electrical system!
7 If protective devices and guards are subject to wear, check them regularly and replace them
in good time!
8 When performing electrical welding work on the vehicle and mounted devices, turn the
power supply off at main battery switch or disconnect generator cable and battery!
9 Replacement parts must at least comply with the technical requirements set by the
manufacturer of the implements! This is guaranteed by original KRONE spare parts!
10 Only use nitrogen for filling pneumatic accumulators - risk of explosion!
Pos: 11.6.17 /BA/Si cherheit/Wartung/ Wartung Zusatz bei Gasspeic herung @ 38\mod_12657871 78167_78.docx @ 349311 @ @ 1
11 Repairs to pretensioned energy stores (springs, accumulators, etc.) require adequate
knowledge and correct assembly tools and may be performed in specialist workshops only!
Pos: 11.6.18 /BA/Si cherheit/Eigenmächtig er Umbau und Ersatztei lherstellung @ 1\mod _1201937705539_78.doc x @ 55745 @ 2 @ 1
4.9 Unauthorised Conversion/Modification and Spare Parts Production
Conversions or modifications of the machine are permitted only with prior consultation with the
manufacturer. Original spare parts and accessories authorised by the manufacturer help to
ensure safety. Use of other parts may void liability for resulting damage.
Pos: 11.6.19 /BA/S icherheit/Unzulässi ge Betriebsweisen @ 11\ mod_1223357699923_78. docx @ 145527 @ 2 @ 1
4.10 Inadmissible Modes of Operation
The operating safety of the delivered machine is guaranteed only when it is used as intended in
compliance with the introductory section "Intended use" of the operating instructions. The limit
values listed in the data charts should not be exceeded under any circumstances.
Pos: 11.7 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
