Krone EasyCut 2801 CV - Install the PTO Shaft; Height of Tractor Lower Suspension Arms

Commissioning
26
Pos: 14.21 /Übersc hriften/Überschri ften 2/F-J/Gelenkwel le montieren @ 2\mod_12023983 42788_78.docx @ 59253 @ 2 @ 1
5.5 Install the PTO shaft
Pos: 14.22 /BA/Er stinbetriebnahme/Gelen kwelle/Mähwerke/A nbau Gelenkwelle masc hinenseitig Bild EC28 00/3200 @ 10\mod_122181 5178476_78.doc x @ 138126 @ @ 1
Figure 6
Pos: 14.23 /BA/Er stinbetriebnahme/Gelen kwelle/Mähwerke/An bau Gelenkwelle masc hinenseitig Text EC 2800/ 3200 @ 10\mod_12218152 74211_78.docx @ 138148 @ @ 1
• Slide the PTO shaft (3) onto the gear input shaft (1) of the swivel gear.
• The safety mechanism must engage.
• Secure the PTO shaft guard against turning with pipe clamp (2).
• Set the PTO shaft down on the PTO shaft support (4).
Make sure the PTO shaft lock has engaged. Never use the safety chains to hold the PTO
shaft in place.
Pos: 14.24 /BA/Sic herheit/Gelenkwelle/A chtung - Schwenkberei ch/Freiraum überpr üfen @ 9\mod_1220536308930_78. docx @ 126898 @ @ 1
Caution! - Swivel range of the PTO shaft
Effect: Damage to the tractor or the machine
• Check the swivel range and clearance of the PTO shaft!
Pos: 14.25 /BA/Er stinbetriebnahme/Gelen kwelle/Traktor wechsel Gelenkwellen länge beachten @ 6\mod_12 14996938591_78.doc x @ 97742 @ @ 1
Caution! - Changing the tractor
Effect: Damage to the machine
When using the machine for the first time and whenever changing the tractor Check PTO shaft
for the correct length. If the length of the PTO shaft does not match the tractor, always observe
the chapter entitled "Adjusting the length of the PTO shaft".
Pos: 14.26 /Übersc hriften/Überschri ften 2/F-J/Höhe der Traktor unterlenker @ 35\mod_ 1257862892625_78.doc x @ 332062 @ 2 @ 1
5.6 Height of tractor lower suspension arms
Pos: 14.27 /BA/Er stinbetriebnahme/Easy Cut/Höhe der Traktorun terlenker EC 2800/3200 @ 10\ mod_122181432221 1_78.docx @ 138082 @ @ 1
Fig. 7:
Perform default setting on a level surface.
The tractor lower suspension arms must be set at a height which ensures that the steerable
pinions are at a height of H approx. 73 cm from the ground.
Pos: 15 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1