Krone EasyCut 2801 CV - Swivelling Parking Support into Transport Position

Start-up
35
Pos: 16.47 /Übersc hriften/Überschri ften 2/A-E/Abstells tütze in Transportste llung schwenken @ 10\mod_ 1221637347634_78. docx @ 135539 @ 2 @ 1
6.10 Swivelling parking support into transport position
Pos: 16.48 /BA/Bedienun g /EasyCut/Abste llstütze/Abstel lstütze eingeklappt Bi ld EC 2800/3200 @ 10\mod_122 2154451514_78.doc x @ 138967 @ @ 1
Figure 15
Pos: 16.49 /BA/Bedienun g /EasyCut/Abste llstütze/Abstel lstütze in Transports tellung schwenken @ 12\mo d_1223983226897_78.doc x @ 149837 @ @ 1
After the machine is attached, swivel the parking support into transport position.
• Use the three-point hydraulic system to raise the parking support somewhat.
• Swivel the parking support (2) into transport position and lock it in place with the bolt (1).
Pos: 17 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1