Krone EasyCut 2801 CV - Switching from Working Position to Transport Position

Driving and Transport
37
Pos: 18.6 /Überschri ften/Überschri ften 2/U-Z/Von Arbeitss tellung in Transports tellung @ 2\mod_120246 6246542_78.docx @ 59681 @ 2 @ 1
7.1 Switching from working position to transport position
Pos: 18.7 /BA/Sic herheit/Fahren und Transpor tWarnung - Umschwenken de s Mähwerks in Transpor tstellung @ 299\mod_141 2927555301_78.doc x @ 2340867 @ @ 1
WARNING!
During the swivelling operation of the mower, persons may be gripped by the mower and
be seriously hurt.
• Before swivelling the mower into transport position, switch off the PTO shaft.
• Do not swing up the machine until
• all machine parts have come to a complete stop.
• there is no one in the swivel range.
Pos: 18.8 /BA/Fahren und Transport/EasyCut/Fa hren-Transpor t Bild EC 2800/3200 @ 10\mod_1222 072538366_78.doc x @ 138764 @ @ 1
Figure 16
Pos: 18.9 /BA/Fahren und Transport/EasyCut/Fa hren/Transpor t Text EC 2800/3200/3210/ 4013 mit QFB @ 10\mod_12220725 73163_78.docx @ 138786 @ @ 1
During transport / road travel the disc mower must be raised.
To do this:
• Switch off PTO drive
• Swivel the parking support into transport position and lock it into position with the bolt (see
chapter on start-up entitled "Swivelling the parking support into transport position").
With cross conveyor option:
• Activate the single-action (red 3) control unit (3) to swivel the cross conveyor into working
position.
• Switch off the control unit.
• Activate the single-action (red 1) control unit (2) to lift the mowing unit.
• Activate the double-action (red2/blue2) control unit (1) to swivel the machine into transport
position.
• Close the shut-off valve (1) on the pressure hose to the double-acting swivel cylinder
(working, transport position).
• Close the shut-off valve (4) on the left lifting cylinder (5) of the wheel arm.
Pos: 18.10 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1