Settings
49
Pos: 22.14 /Übersc hriften/Überschri ften 2/A-E/Einstell ung Bodendruck @ 10\mod_12 22263655765_78.doc x @ 139441 @ 2 @ 1
9.3 Setting of the Ground Pressure
Pos: 22.15 /BA/Einste llungen/Mähwerke/Ea syCut/Bodendruc k/Bodendruck allge meiner Text alle EC @ 0\mod_11966 67271181_78.doc x @ 10190 @ @ 1
The ground pressure for the cutter bar is adjusted to local conditions by means of the
compensation springs. In order to protect the sward the load on the mowing spar must be
relieved so that it does not jump when mowing, yet does not leave any skid marks on the
ground.
Pos: 22.16 /BA/Einste llungen/Mähwerke/Ea syCut/Entlas tungsfeder(n)/Entl astungsfeder Bild EC 280 1/3201/3600 @ 307\mod_1416 381125102_78.doc x @ 2382807 @ @ 1
X
EasyCut 2801 50 mm
EasyCut 3201 25 mm
EasxCut 3600 25 mm
EC-531-0
Fig. 28
Pos: 22.17 /BA/Einste llungen/Mähwerke/Ea syCut/Entlas tungsfeder(n)/Entl astungsfeder/Bode ndruck einstellen EC 28 00/3200/3210/4013 @ 10\mod_1222263837578_7 8.docx @ 139487 @ @ 1
The ground pressure can be adjusted through threaded spindles (1). To set the ground
pressure the machine must be lifted.
Pos: 22.18 /BA/Einste llungen/Mähwerke/Ea syCut/Entlas tungsfeder(n)/W erksseitige Einstellung der Entlastungsfeder n @ 39\mod_12677897907 25_78.docx @ 357425 @ @ 1
The relieving springs have been preset to dimension “X” at the factory (see table).
Pos: 22.19 /Übersc hriften/Überschri ften 2/A-E/Einstell ung zur Traktorspur @ 35\mo d_1257926368191_78.doc x @ 334782 @ 2 @ 1
9.4 Setting for tractor track
Pos: 22.20 /BA/Einste llungen/Mähwerke/Ea syCut/Einstell ung zur Traktorspur EC 2800 CV / 3200 CV @ 10\mod_122226509 2187_78.docx @ 139597 @ @ 1
Figure 29:
The double-action hydraulic cylinder (4) moves the disc mower from transport to working
position. There are three attachment positions available for the track setting. We recommend
the middle position (2).
Pos: 22.21 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
