Maintenance
59
Pos: 26.13 /Übersc hriften/Überschri ften 2/A-E/Anziehdreh momente über Innensechs kant @ 202\mod_13857118 34702_78.docx @ 16930 94 @ 2 @ 1
10.4 Tightening torques (countersunk screws)
Pos: 26.14 /BA/W artung/Drehmomente / Anziehdr ehmomenteAnziehdr ehmomente über Innensec hskant Tabelle (2015-02- 25 06:59:01) @ 306\mod _1415966644585_78.doc x @ 2378535 @ @ 1
Tightening torque MA in Nm (unless
otherwise indicated).
A = thread size
(the stability class can be seen on the head of the
screw).
Ø
5.6 8.8 10.9 12.9
M
A
(Nm)
M 4
2.5 3.5 4.1
M 5
4.7 7 8
M 6
8 12 15
M 8
20 29 35
M 10
23 39 58 67
M 12
34 68 100 116
M 14
108 160 188
M 16
168 248 292
M 20
340 488 568
A
BM 400 0234
NOTE
The table above does not apply to countersunk screws with hexagonal socket and metric
thread which are tightened via hexagonal socket.
Pos: 26.15 /Übersc hriften/Überschri ften 3/A-E/A/Abweichend es Drehmoment @ 0\mod_119 6950054171_78.doc x @ 15312 @ 3 @ 1
10.4.1 Deviating Torque
Pos: 26.16 /BA/W artung/Drehmomente / Anziehdr ehmomente/Abweic hendes Drehmoment EasyC ut @ 3\mod_120488573751 5_78.docx @ 73465 @ @ 1
Screws / nuts MA [Nm]
Nut for cutting disc flange 850
Nut for shear protection (rotary hub) 300
Bearing housing for cutting disc 50
Bearing housing for blade drum 50
Pos: 26.17 /BA/W artung/Muttern und Schraube n (50h) anziehen @ 0\mod_1196 949864530_78.doc x @ 15293 @ @ 1
Note
Regularly check that nuts and bolts are tightly in place (approx. every 50 hours) and tighten
them if necessary.
Pos: 26.18 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
