Maintenance – lubrication chart
86
Pos: 31.1 /Überschri ften/Überschri ften 1/U-Z/Wartung - S chmierplan @ 0\mod_1197359304 198_78.docx @ 18232 @ 1 @ 1
11 Maintenance – lubrication chart
Pos: 31.2 /Überschri ften/Überschri ften 2/P-T/Spezielle Si cherheitshinweise @ 0\ mod_1196660495760_78. docx @ 9134 @ 2 @ 1
11.1 Special Safety Instructions
Pos: 31.3 /BA/Sic herheit/7. Gefahrenhi nweise alt/Mähwerke/ Warnung - Reparatur_W artung_Reinigungs_ 4 allgemein EasyCut @ 292\ mod_1410941423112_78. docx @ 2299026 @ @ 1
WARNING!
When performing repair, maintenance or cleaning work or in case of technical
intervention, drive elements may start moving (caution: cutting discs continue to run).
Effect: Danger to life, injuries or damage to the machine.
• Turn off the PTO shaft.
• Move the machine to the working position and lower it to the ground.
• Switch off the engine of the tractor, remove the ignition key and carry it with you.
• Secure the tractor against accidental start-up and against rolling.
• After the repair, maintenance, cleaning work or technical modifications are completed,
mount all protective covers and safety devices properly again.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a physician
immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 31.4 /Überschri ften/Überschri ften 2/F-J/Gelenkwell e @ 0\mod_1199781879794_7 8.docx @ 34542 @ 2 @ 1
11.2 PTO shaft
Pos: 31.5 /BA/War tung/Gelenkwelle schmier en/Abschmieren Gelen kwelle EasyCut 100 h @ 44\mod _1275544141265_78. docx @ 392033 @ @ 1
Fig. 58
Lubricate the PTO shafts at the intervals indicated in the drawing with a multi-purpose grease.
Follow the operating instructions of the PTO shaft manufacturer.
Pos: 31.6 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
