Krone EasyCut 2801 CV - Lubricating the Intermediate PTO Shaft

Maintenance – lubrication chart
87
Pos: 31.7 /Überschri ften/Überschri ften 2/A-E/Abschmier en der Zwischengelenk wlle @ 35\mod_12579333546 60_78.docx @ 334907 @ 2 @ 1
11.3 Lubricating the intermediate PTO shaft
Pos: 31.8 /BA/War tung/Gelenkwelle schmieren/ Abschmieren Zwisc hengelenkwlle EC 2800/ 3200 @ 10\mod_12223238944 58_78.docx @ 139917 @ @ 1
AMT-1-023
1 2
Figure 59:
The profile pipes on the intermediate PTO shaft must be lubricated every 20 operating hours.
To do this, manually push back the guard (2) and twist the protective tubes in opposite
directions until the lubrication point becomes visible.
Pos: 31.9 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1