Maintenance – lubrication chart
88
Pos: 31.1 /Übersc hriften/Übersc hriften 1/U-Z/ Wartung - Schmier plan @ 0\mod _1197359304198 _78.docx @ 18232 @ 2 @ 1
11 Maintenance – lubrication chart
Pos: 31.2 /Übersc hriften/Übersc hriften 2/P-T/Spezi elle Sicher heitshinweise @ 0\mod_11966 60495760_78.d ocx @ 9134 @ @ 1
11.1 Special Safety Instructions
Pos: 31.3 /BA/Sich erheit/Gefahr enhinweise/M ähwerke/Gefahr - Re paratur_Wart ung_Reinigu ngs_4 allgemei nE asyCut @ 1 1\mod_12236201 98301_78.doc x @ 148349 @ 2@ 1
Danger! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving (caution, the cutting
discs continue to run).
Effect: Danger to life, injuries or damage to the machine.
• Move the machine to the working position and lower it to the ground
• Switch off the tractor engine and remove the ignition key.
• Secure the tractor against accidental start-up and against rolling.
• Switch off the PTO and disengage it.
• After repair, maintenance, cleaning work or technical modifications are complete, mount
all protective coverings and safety devices again properly.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a doctor
immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 31.4 /Übersc hriften/Übersc hriften 2/F-J/Gele nkwelle @ 0\m od_11997818 79794_78.doc x@ 34542 @ @ 1
11.2 PTO shaft
Pos: 31.5 /BA/W artung/Gelenkwelle schmier enAbschmieren Gel enkwelle Eas yCut 100 h @ 4 4\mod_127554 4141265_78.doc x @ 392033 @ @ 1
Fig. 56
Lubricate the PTO shafts at the intervals indicated in the drawing with a multi-purpose grease.
Follow the operating instructions of the PTO shaft manufacturer.
Pos: 31.6 /BA/---- ------- ----Seitenumbruch----- ----------- @ 0\mo d_11961753112 26_0.docx @ 41 65 @ @ 1
To Next Page
Loading...
