Commissioning
24
5.4 PTO shaft
5.4.1 Length adjustment
Figure
The ends of the PTO shaft which has been provided are equipped with a longer and a shorter
guard over the joints. The joint with the longer guard must be pushed onto the gear input shaft
towards the machine.
The machine is connected to three-point linkage of tractor.
The length of the universal shaft (1) must be adapted.
• Disassemble universal shaft.
• Install one half on tractor side (1) and the other one on machine side (2).
• Check overlap of section tubes and guard tubes.
• Shorten section tubes and guard tubes so that the universal shaft can move freely in the
shortest operating position.
• For further procedure, please refer to the operating instructions of universal shaft
manufacturer.
To Next Page
Loading...
