EasyManua.ls Logo

Krone EasyCut 6210 CV - 6 Start-Up; Parking Brake

Krone EasyCut 6210 CV
98 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Start-up
27
6 Start-up
Danger! - Attaching / removing and operating the machine
Effect: Danger to life or serious injuries.
No persons may remain between the tractor and the machine.
Nobody should be in the swivel / working range of the machine!
Only perform jobs under or on the machine when it is raised if it is securely supported.
Setting tasks must only be performed when the drive is switched off and the engine is at a
standstill!
Switch off the engine, remove the ignition key, and secure the machine from rolling away.
6.1 Parking Brake
The parking brake is used to secure the machine from rolling away accidentally, especially
when the machine is disconnected from the tractor.
Fig.
7
The crank (1) for the parking brake is located on the left-hand side of the machine above the
transport wheel.
After the machine is attached to the tractor, release the parking brake.
To apply the parking brake:
Turn the crank clockwise until the resistance grows noticeably greater.
Releasing the parking brake:
Turn the crank anti-clockwise until the brake cable is slightly slack.

Table of Contents

Related product manuals