Krone EasyCut 6210 CV - Page 44

Operation
44
1
2
3
4
5
6
Fig.
21
• Swivel the parking support (2) down and lock it in place with the bolt (1). Secure bolt with
spring cotter pin.
• Via the tractor hydraulics, lower the machine to the ground.
• Remove the PTO shaft guard retaining chains. Remove the PTO shaft from the PTO and
place it onto the PTO shaft support (3).
• Uncouple the lower suspension arm. Pull out the electrical connection cable between tractor
and machine from the plug on the tractor.
• Close the shut-off valve (4).
• Depressurise the hydraulic system. Move the control valves on the tractor into the float
position.
• Disconnect the hydraulic hoses (5).
• First disconnect the compressed air hose with the red coupling connection, then disconnect
the compressed air hose with the yellow coupling connection.
• Pull out the electrical connection cable between tractor and machine from the plug on the
tractor.
• Place the connection cable, hydraulic and compressed air hoses in the support on the
machine.
• Disconnect the lower suspension arm.