Krone EasyCut 6210 CV - Adjusting the Tedder Speed

Settings
49
9.4 Adjusting the Tedder Speed
Danger! - Settings on the machine
Effect: Danger to life, injuries or damage to the machine.
• Setting tasks must only be performed when the drive is switched off and the engine is at a
standstill! Remove the ignition key!
EC-119-3
1
2
3
II
I
I
II
Figure
26
Two tedder speeds can be set on the speed gearbox. This affects the conditioning effect and
the power consumption.
Minimum speed: 600 rpm.
Maximum speed: 900 rpm.
• Unscrew the wing screw (1) from the actuating lever (2).
• Rotate the actuating lever (2) 180°. In doing so, turn the mower drum (3) so that the
actuating lever can be rotated completely.
• Secure the actuating lever (2) with the wing screw (1).