To this Document
6
2 To this Document
2.1 Validity
These operating instructions apply to disc mowers of the series:
EasyCut 6210 CV
2.2 Re-Ordering
If this document has become unusable in whole or in part, you can order a replacement, quoting
the document number on the cover sheet. Contact data can be found in the chapter “Contact
persons”.
The document can additionally be downloaded via the KRONE Media Center
http://www.mediathek.krone.de//.
2.3 Further applicable documents
To ensure that the machine is used safely and as intended, observe the following further
applicable documents:
– Operating instructions of universal shaft(s)
2.4 Target group of this document
This document aims at the operators of the machine fulfilling the minimum requirements of
personnel qualification; refer to chapter entitled Safety “Personnel Qualification”.
2.5 How to use this document
2.5.1 Directories and References
Table of contents/headers:
The table of contents as well as the headers in this instruction are used for quick navigation in
the chapters.
Index directory:
In the index directory, you can find information on the desired subject via catchwords which are
in alphabetical order. The index directory can be found on the last page of this instruction.
Cross references:
Cross references to another place in the operating instructions or to another document are in
the text and specify the chapter and subchapter or section. The designation of subchapters or
sections is presented in quotation marks.
Example:
Check that all screws on the machine are tight, refer to chapter Maintenance, “Tightening
Torques”.
The subchapter or the section can be found via an entry in the table of contents and in the index
directory.
To Next Page
Loading...
