Krone EasyCut 7540 - Adjusting the Tedder Speed

Settings
62
Pos: 21.35 /Überschrif ten/Überschrif ten 2/A-E/Ein stellung der Ze tterdrehzahl @ 0 \mod_1196 668564463_78.doc @ 10266
9.7 Adjusting the Tedder Speed
Pos: 21.36 /Ab kürzungen /Abkürz ungen sprac hneutral/EasyC ut/EasyCut 914 0CV @ 11\mod_1223 444731538_0.d oc @ 146416
(EasyCut 9140 CV)
Pos: 21.37 /BA/Sic herheit/Gefahre nhinweise/Ei nstellungen an d erM aschine @ 0 \mod_119666 8628056_78. doc@ 10285
Danger! - Settings on the machine
Effect: Danger to life, injuries or damage to the machine.
• Setting tasks must only be performed when the drive is switched off and the engine is at
a standstill! Remove the ignition key!
Pos: 21.38 /BA/Ei nstellungen/M ähwerke/Zetterdr ehzahl/Zetterdr ehzahl Bild EC2 80/320 CV-Q @ 10\mod_1221550 487745_78.doc @ 134924
EC-2-119
600
900
Figure 33
Pos: 21.39 /BA/Ei nstellungen/M ähwerke/Zetterdr ehzahl/Zetterdr ehzahl einstell en 600/900 @ 11\ mod_122361 3453645_78.doc @ 148195
Two tedder speeds can be set on the speed gearbox. This affects the conditioning effect and
the power consumption.
Minimum speed: 600 rpm.
Maximum speed: 900 rpm.
• Unscrew the wing screw (1) from the actuating lever (2).
• Rotate the actuating lever (2) 180°. In doing so, turn the mower drum (3) so that the
actuating lever can be rotated completely.
• Secure the actuating lever (2) with the wing screw (1).
Pos: 21.40 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65