Krone EasyCut 9140 CV - Replacing the Hydraulic Oil Filter

Special equipment
113
Pos: 31.47 /BA/So nderausstatung /EasyCut / AM M ähwerke/Qu erförderer/Hydra ulikölfilter ersetze n EC 9140 @ 10\mod_122233 6185786_78.doc @ 140695
14.10.5 Replacing the hydraulic oil filter
EC800044
Figure 70
Note
Ensure total cleanliness when changing the filter
Properly dispose of filter cartridge that was removed
Replace the hydraulic oil filter before every season (but at least once year)
• Unscrew the screw cover (1).
• Lift the filter insert (2) and allow hydraulic oil to drip out.
• Remove the filter insert and dispose of it correctly.
• Moisten the seal surface of the new filter insert with oil and set it in place.
• Tighten the screw cover (1).
Pos: 32 /BA/----- Seitenumbruch---- -- @ 0\mod_1 196175311226 _0.doc @ 416 5