Commissioning
30
Pos: 13.15 /Überschrif ten/Überschrif ten 2/K-O/Ko ppelstange ei nstellen @ 79\m od_131494014 3932_78.doc @ 699428
5.4 Setting the coupling rod
Pos: 13.16 /Ab kürzungen /Abkürz ungen sprac hneutral/EasyC ut/EasyCut 100 00 Shift @ 41\ mod_1271851241 507_0.doc @ 373499
(EasyCut 10000 Shift)
Pos: 13.17 /BA/Ers tinbetriebna hme/EasyCut/Kop pelstange ei nstellen @ 79\mo d_131494082 5059_78.doc @ 699456
EC-319-0
Fig. 7
Procedure:
• The machine must be properly connected to the tractor
• Bring machine into transport position with tractor rear hydraulics
• P.T.O. shaft drive and tractor engine OFF
• Activate tractor parking brake
• Remove the ignition key
• Pull the locking bolt (1) and bring into position III (right hand and left hand side)
• Make sure by visual contact that the locking bolt (1) is located in the centre of the oblong
hole (pos. III)
If this is not the case, the coupling rod (2) must be adjusted via the threaded piece (3) in
a way that the locking bolt is located in the centre of the oblong hole
Pos: 13.18 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
