Settings
57
Pos: 21.11 /Überschrif ten/Überschrif ten 2/U-Z/Ü berschnitt einstelle n @ 79\mod_13 14875045910 _78.doc @ 69 8940
9.3 Adjust overcut
Pos: 21.12 /Ab kürzungen /Abkürz ungen sprac hneutral/EasyC ut/EasyCut 100 00 Shift @ 41\ mod_1271851241 507_0.doc @ 373499
(EasyCut 10000 Shift)
Pos: 21.13 /BA/Ei nstellungen/M ähwerke/EasyCut /Überschnitt ein stellen EC 10 000 Shift / EC B 9 70 @ 79\mod _13148768221 08_78.doc @ 699024
EC-319-0
Fig. 28
The overcut to the front mowing unit can be reduced or enlarged with the outrigger arms (2)
(right and left side of machine).
Pos.I = max. mowing width
Pos.II = increase overcut by 7,5 cm (on each side)
Pos.III = increase overcut by 15 cm (on each side)
Procedure:
• The machine must be properly connected to the tractor
• Bring machine into transport position with tractor rear hydraulics
• P.T.O. shaft drive and tractor engine OFF
• Activate tractor parking brake
• Remove the ignition key
WARNING! - Outrigger arm can slip out.
Risk of injury due to crushing.
The locking bolt (1) must be properly engaged in one of the positions (I, II or III).
• Pull the locking bolt (1) and bring into desired position (adjust right hand and left hand
side identically)
• Make certain that the locking bolt engages properly
Pos: 21.14 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
