Settings
64
Pos: 21.46 /Überschrif ten/Überschrif ten 2/A-E/Ein stellung der P fahlsicherung @ 9\mod_1220961 168693_78.doc @ 130388
9.9 Setting of the pole protection mechanism
Pos: 21.47 /BA/Sic herheit/Eas yCut/Einstellung and er Pfahlsicheru ng @ 9\mod_12 20960955600_ 78.doc @ 130 367
Caution! - Adjusting the pole protection mechanism
Effect: Damage to the machine
• If the setting value is changed, the trigger moment will also change. If the spring on the
pole protection mechanism is pretensioned more than prescribed by the manufacturer,
there is a risk of damaging the disc mower.
• The spring on the pole protection mechanism must be tensioned at least to the extent
that the pole protection mechanism does not respond in transport position even with
abrupt loads.
Pos: 21.48 /BA/Ei nstellungen/M ähwerke/EasyCut /Pfahlsicher ung/Pfahlsicheru ng Bild EC7540/ 9140 @ 11\mo d_122345607 7022_78.doc @ 1 46857
Fig. 35
Pos: 21.49 /BA/Ei nstellungen/M ähwerke/EasyCut /Pfahlsicher ung/Pfahlsicheru ng allgemein @ 9\ mod_122096 1293021_78.doc @ 130429
In order to protect the disc mower against damages during driving over obstacles, it is equipped
with a so-called pole protection mechanism.
The optimal setting for the trigger moment takes place in the factory.
Pos: 21.50 /BA/Ei nstellungen/M ähwerke/EasyCut /Pfahlsicher ung/Pfahlsicheru ng EC 7540/914 0/10000 Shift Ta belle @ 41\ mod_127185199575 7_78.doc @ 3 73551
Mower type Dimension x
EASYCUT 7540 85 mm
EASYCUT 9140 85 mm
EASYCUT 9140 CV 85 mm
EASYCUT 10000 Shift 85 mm
Pos: 21.51 /BA/Ei nstellungen/M ähwerke/EasyCut /Pfahlsicher ung/Pfahlsicheru ng nach dem A uslösen EC 754 0/9140 @ 11\m od_12234565 99053_78.doc @ 146901
After the pole protection mechanism is triggered, the mowing unit swings back. The pole
protection mechanism will catch again as soon as you move back.
Pos: 21.52 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
