Krone EasyCut 9140 CV - Wide Spreading with the Cross Conveyor Option

Settings
67
Pos: 21.64 /Überschrif ten/Überschrif ten 3/A-E/Breit ablage bei Op tion Querförd erband @ 11\ mod_122345745 4069_78.doc @ 1 46943
9.10.3 Wide spreading with the "Cross Conveyor" option
Pos: 21.65 /BA/Ei nstellungen/M ähwerke/Schwa dbreite / Breita blage/Einstellung Br eitablage Bild EC 7140/9540 mit QFB @ 75\mo d_1309345800628 _78.doc @ 662 220
EC800039_1
2
2
1
1
2
3
3
4
Fig. 38
Pos: 21.66 /BA/Ei nstellungen/M ähwerke/Schwa dbreite / Breita blage/Einstellung Br eitablage Te xtZ usatz EC 7540/ 9140 QFB @ 1 1\mod_12234 57573803_78.doc @ 146965
Cross conveyor is not use
Pos: 21.67 /BA/Ei nstellungen/M ähwerke/Schwa dbreite / Breita blage/Einstellung Br eitablage Te xtEC 280/320 CV-Q @ 10\mod_1221 552107276_7 8.doc @ 135012
The tedder flaps (1) are fully open. Mount the deflector plates (2) as shown here. Depending on
the operating conditions, the deflector plates (2) may have to be adjusted to provide for equal
distribution across the entire area.
Pos: 21.68 /BA/Ei nstellungen/M ähwerke/Schwa dbreite / Breita blage/Einstellung Br eitablage Te xtZ usatz EC 7540/9140 QFB (QFB wird eingesetzt) @ 75\mod_130 9346322909_ 78.doc @ 662278
Cross conveyor in use
For use with the cross conveyor activated, we recommend removing the wide distributor
plates (2).
To do this:
• Loosen the ring screws (3) to remove the wide distributor plates (2)
• Insert the wide distributor plates in the support (4) on the light holder and fasten them in
place with ring screws (3)
Pos: 22 /BA/----- Seitenumbruch---- -- @ 0\mod_1 196175311226 _0.doc @ 416 5