KRONE ISOBUS-Terminal CCI 100
103
Pos: 61.46.30 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ Hauptmenüs/Haupt menüs alte Ausführung/ Hauptmenü 2 Zähler/ Menü 2-1 Kundenzähler @ 118\mo d_1341919634380_78.doc x @ 1028744 @ 3 @ 1
11.3.1 Menu 2-1 „Customer Counter“
CCS00013
2-1
n
all
Fig. 63
Calling the Menu
Main menu 2 "Counter" is displayed
• Select menu 2-1
by pressing function key or (the symbol is highlighted in
grey)
• Press function key
The display shows menu 2-1 "Customer Counter".
Meaning of the Symbols:
Operating hours counter
Counter surface
Customer counter (1-20)
Note
• The operating hours counter (
) is not counting until the operating hours counter is
activated, the electronics is switched on and the P.T.O. shaft is running).
• The area counter (
) does only appear if the appropriate parameter is released in main
menu 6 “Technician”
• The area counter (
) counts when the tractor transmits the signal forward travel to
the job computer and at least one mowing unit is in use. The area counter stops as
soon as the tractor is stopped or no mowing unit is in use.
• The displayed area must not correspond to the real mowed area as it is also possible
that mowing is carried out with tractors which have not send the forward travel signal
• The customer counter (
) indicates the operating time as well as the mowed area of
the machine. The customer counter can be deleted
The background of the activated customer counter (in this case customer counter 1) is grey.
The selected customer counter is located between the two crossbars (here customer counter 2).
Pos: 61.46.31 /Layout Module /---------------Seitenumbruch--------------- - @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
