KRONE ISOBUS-Terminal CCI 100
126
Pos: 61.46.60 /BA/I nfo-Center/CCI- ISOBUS-Terminal/ISOBUS/ Menü 9 ISO-Einstellu ngen/Menü 9-2 Terminal wechsel @ 119\mod_134208 7866195_78.doc x @ 1070148 @ 3 @ 1
11.7.2 Menu 9-2 „Switching Between the Terminals“
Note
• Menu 9-2 appears only if several ISO terminals are connected.
• Changing to the next connected terminal is possible via menu 9-2 (depending on how many
terminals are connected).
• When switching for the first time, the configuration of the machine is loaded into the next
terminal. The loading process may take a few minutes. The configuration is laid down in the
accumulator of the next terminal.
Note
Up to the next call, the machine is no longer available in the previous terminal.
Note
In case of a restart, the system tries at first to start the last used terminal. If the last used
terminal is not available any longer, the restart is delayed as the system is searching for a
new terminal and loads the specific menus into the terminal. The loading process may
take a few minutes.
CC000484
9
Fig. 81
• Bring up the menu level by pressing function key
from the basic screen
• Select main menu 9 (
) by pressing function key or , the symbol is highlighted in
grey.
• Pressing the function key
brings up the menu level 9-2 ( ) . The symbol is
highlighted in grey.
• Changing to the next connected terminal is possible by pressing the key
once again
• Pressing the function key
closes the menu currently displayed
• Pressing the function key
and holding it down brings up the basic screen
Pos: 61.46.61 /Layout Module /---------------Seitenumbruch--------------- - @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
