Krone EasyCut B 1000 CV - Alarm Message Reference

KRONE ISOBUS-Terminal CCI 100
128
Pos: 61.46.64 /Übersc hriften/Überschri ften 2/A-E/Alarmmel dungen @ 19\mod_123857245 7463_78.docx @ 221082 @ 2 @ 1
11.9 Alarm messages
Pos: 61.46.65 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ AlarmmeldungenAllge meine Alarmmeldungen Tabelle EC B 1000 (2014-10-14 16: 17:34) @ 200\mod_1385 454797389_78.docx @ 168 2836 @ @ 1
No. Figure Possible cause Remedy
A0
1
– The plug-in fuse in the job computer is
defective.
– Short circuit on electrical outputs
+12V2FU_L
– Check the connection
for short circuit and
replace the fuse.
A0
2
A02
FUSE
12V Pow3
– Fuse in the job computer defective
– Short circuit on electrical outputs
+12V3FU_L
– Check the connection
for short circuit.
– The fuse resets itself
after the unit has cooled
down.
A0
4
A04
– The connection to the multi-function lever is
interrupted.
– The multi-function lever is not connected
properly.
– Check the wiring of the
multi-function lever.
A1
4
– Undervoltage
– The tractor battery is defective.
– The dynamo of the tractor is too low.
– 12V power supply is too weak on tractor side
or not correctly connected with the battery.
– Connect KRONE
connection cable
directly to the battery of
the tractor.
A1
5
– Overvoltage
– The dynamo of the tractor is defective.
– Check dynamo.
A2
1
A21
PIC-I01
– CAN connection is interrupted between job
computer and KRONE-PIC I/1 computer.
– CAN wiring is defective.
– KRONE-PIC-I01 computer is inactive.
– Check CAN wiring.
– Replace KRONE-PIC-
I01 computer.
A2
2
A22
PIC-I02
– CAN connection is interrupted between job
computer and KRONE-PIC I/2 computer.
– CAN wiring is defective.
– KRONE PIC-I02 computer is inactive.
– Check CAN wiring.
– Replace KRONE-PIC-
I02 computer.
Pos: 61.46.66 /Layout Module /---------------Seitenumbruch--------------- - @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1