EasyManua.ls Logo

Krone EasyCut B 1000 CV - Settings; Adjusting Cutting Height

Krone EasyCut B 1000 CV
244 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Settings
153
Pos: 71.1 /Überschri ften/Überschrif ten 1/A-E/Einstellunge n @ 0\mod_1199868783862_7 8.docx @ 36141 @ 1 @ 1
15 Settings
Pos: 71.2 /BA/Sic herheit/7. Gefahrenhin weise alt/Mähwerke/Gef ahr - Einstellarbei ten angebaute Maschi nen (2014-04-14 17:04:36) @ 6\mod_1214455875276 _78.docx @ 94250 @ @ 1
Danger! - Unexpected movements of the machine
Effect: Danger to life or serious injuries.
Setting tasks must only be performed when the drive is switched off and the engine is at a
standstill!
Switch off the engine
Remove the ignition key.
Secure the tractor against rolling.
Pos: 71.3 /BA/Sic herheit/7. Gefahrenhin weise alt/Gefahr - Unfa llgefahr durch unbeabsi chtiges Senken des Quer förderers @ 101\mod_133 0612168305_78.doc x @ 898030 @ @ 1
Danger!
Accident hazard through unintentional lowering of the cross conveyor.
Effect: Danger to life or serious injuries.
Work may only be done under the raised cross conveyor when the cross conveyor
stopcock is closed.
Pos: 71.4 /Überschri ften/Überschrif ten 2/A-E/Einstellen der Schnitthöhe @ 0\mod_119666 0879619_78.doc x @ 9191 @ 2 @ 1
15.1 Adjusting the cutting height
Pos: 71.5 /BA/Einste llungen/Mähwerke/Sc hnitthöhe/Schni tthöhe Bild EC B 1000 @ 100\mod_1330 082415443_78.doc x @ 889947 @ @ 1
Fig. 96
Pos: 71.6 /BA/Sic herheit/7. Gefahrenhin weise alt/Sicherheits hinweise am Anfang des Kapi tels beachten @ 101\ mod_1330611811687_78. docx @ 897943 @ @ 1
Observe the safety instructions at the beginning of the section.
Pos: 71.7 /BA/Einste llungen/Mähwerke/Sc hnitthöhe/Schni tthöhe größer_geringer EC280/320 @ 9\mod_1220960 304209_78.docx @ 1302 71 @ @ 1
The cutting height is adjusted via the top link (1).
To do this:
Swivel the parking support(s) down
Lower the machine into working position and set it down on the parking support(s).
Rotate the top suspension arm (1).
Fold in the parking support(s).
Top suspension arm longer = bigger cutting height
Top suspension arm shorter = smaller cutting height
Pos: 71.8 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1

Table of Contents

Related product manuals