Settings
156
Pos: 71.21 /Überschr iften/Überschrif ten 2/A-E/Einstellung der Zetterdrehzahl @ 0\ mod_1196668564463_78. docx @ 10266 @ 2 @ 1
15.4 Adjusting the Tedder Speed
Pos: 71.22 /Abkürzungen / CV-Ausführung @ 95\ mod_1328530180147_78. docx @ 799128 @ @ 1
CV-Design
Pos: 71.23 /BA/Sic herheit/7. Gefahrenhin weise alt/Einstellar beiten / Einstellun gen/Gefahr - Einste llungen an der Maschine @ 0\ mod_1196668628056_78.doc x @ 10285 @ @ 1
Danger! - Settings on the machine
Effect: Danger to life, injuries or damage to the machine.
• Setting tasks must only be performed when the drive is switched off and the engine is at a
standstill! Remove the ignition key!
Pos: 71.24 /BA/Einste llungen/Mähwerke/ Zetterdrehzahl/Z etterdrehzahl Bild EC B 1000 CV/ 3600/ 3201/ BM 500/ BM420 Fron tmähwerk/ (600/900) @ 210\ mod_1389161970831_78. docx @ 1730615 @ @ 1
EC-466-0
600
900
3
1
2
Fig. 99
Pos: 71.25 /BA/Einste llungen/Mähwerke/ Zetterdrehzahl/Z etterdrehzahl einst ellen 600/900 @ 11\mod_122 3613453645_78.doc x @ 148195 @ @ 1
Two tedder speeds can be set on the speed gearbox. This affects the conditioning effect and
the power consumption.
Minimum speed: 600 rpm.
Maximum speed: 900 rpm.
• Unscrew the wing screw (1) from the actuating lever (2).
• Rotate the actuating lever (2) 180°. In doing so, turn the mower drum (3) so that the
actuating lever can be rotated completely.
• Secure the actuating lever (2) with the wing screw (1).
Pos: 71.26 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
