Settings
158
Pos: 71.33 /Überschr iften/Überschrif ten 3/A-E/E/Einste llung bei Schwadablage @ 3\ mod_1204713732476_78. docx @ 72183 @ 3 @ 1
15.5.1 Adjustment for Swathing
Pos: 71.34 /Abkürzungen / CV-Ausführung @ 95\ mod_1328530180147_78. docx @ 799128 @ @ 1
CV-Design
Pos: 71.35 /BA/Einste llungen/Mähwerke/Sc hwadbreite / Brei tablage/Einstellung d er Schwadablage Bild EC280/ 320 CV / B 1000 CV @ 103\mod_1331793 832879_78.doc x @ 938098 @ @ 1
A
B
EC-371-1
Fig. 101
Pos: 71.36 /BA/Sic herheit/7. Gefahrenhin weise alt/Sicher heitshinweise am Anfang des Ka pitels beachten @ 101\ mod_1330611811687_7 8.docx @ 897943 @ @ 1
• Observe the safety instructions at the beginning of the section.
Pos: 71.37 /BA/Einste llungen/Mähwerke/Sc hwadbreite / Brei tablage/Einstellung d er Schwadablage Text EC R 280/ 320 CV / B 1000 CV @ 91\mod_13261807802 37_78.docx @ 777259 @ @ 1
The swath width can be adjusted to the crop
To do this:
• Loosen the ring nut (1) (right and left machine side)
• Adjust the swath flaps (2) (ensure that right and left machine side have the same settings)
• to the outside “A” = wide swath
• to the inside “B” = close swath
• Tighten ring nut (1)
Pos: 71.38 /BA/Einste llungen/Mähwerke/Sc hwadbreite / Brei tablage/Schwadklappe nverlängerung eins tellen @ 60\mod_129785340 6559_78.docx @ 561524 @ @ 1
The swath width can also be set using the extension on the swath flaps.
To do this:
• Loosen the star knobs (1) (right and left sides of machine)
• Set swath flap extension (3)
• Tighten the star knobs (1)
Pos: 71.39 /BA/Einste llungen/Mähwerke/Sc hwadbreite / Brei tablage/Hinweis Kreuz griffe @ 59\mod_1297431 749350_78.docx @ 558246 @ @ 1
Note
The star knobs may work loose due to vibrations, possibly resulting in the loss of the star
knobs, screws and swath plates.
• Manually tighten star knobs as tight as possible to ensure that they cannot work loose
during operation due to vibrations
Pos: 71.40 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
