Krone EasyCut B 1000 CV - Wide Spreading Adjustment

Settings
159
Pos: 71.41 /Überschr iften/Überschrif ten 3/A-E/B/Brei tablage @ 3\mod_1204713764351_ 78.docx @ 72202 @ 3 @ 1
15.5.2 Wide spreading
Pos: 71.42 /Abkürzungen / CV-Ausführung @ 95\ mod_1328530180147_78. docx @ 799128 @ @ 1
CV-Design
Pos: 71.43 /BA/Einste llungen/Mähwerke/Sc hwadbreite / Brei tablage/Hinweis Kreuz griffe @ 59\mod_1297431 749350_78.docx @ 558246 @ @ 1
Note
The star knobs may work loose due to vibrations, possibly resulting in the loss of the star
knobs, screws and swath plates.
• Manually tighten star knobs as tight as possible to ensure that they cannot work loose
during operation due to vibrations
Pos: 71.44 /BA/Einste llungen/Mähwerke/Sc hwadbreite / Brei tablage/Einstellung Br eitablage Bild EC 280/320 CV -Q -1 @ 59\mod_12974329061 66_78.docx @ 558301 @ @ 1
EC-372-0
A
Fig. 102
Pos: 71.45 /BA/Sic herheit/7. Gefahrenhin weise alt/Sicher heitshinweise am Anfang des Ka pitels beachten @ 101\ mod_1330611811687_7 8.docx @ 897943 @ @ 1
• Observe the safety instructions at the beginning of the section.
Pos: 71.46 /BA/Einste llungen/Mähwerke/Sc hwadbreite / Brei tablage/Einstellung Br eitablage Text EC 280/ 320 CV-Q -1 @ 59\mod_1297432972430_ 78.docx @ 558328 @ @ 1
Swivel the swath flaps (2) all the way outwards (towards “A”).
Depending on the operating conditions, the deflector plates (3) may have to be adjusted to
obtain equal distribution across the entire area.
• Loosen star knob (1)
• Push the deflector plate (3) into the required position
• Tighten the star knobs (1)
Pos: 71.47 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1