Settings
164
Pos: 71.63 /Überschr iften/Überschrif ten 2/U-Z/Verriegelung ei nstellen @ 91\mod_13261 77560227_78.doc x @ 777175 @ 2 @ 1
15.6 Adjust Locking
Pos: 71.64 /BA/Einste llungen/Mähwerke/Ea syCut/Verriegel ung einstellen Bild EC R 280/3 20 CV @ 91\mod_1326177685 810_78.docx @ 777203 @ @ 1
1
EC-363-0
EC-402-0
2
3
Fig. 105
Pos: 71.65 /BA/Sic herheit/7. Gefahrenhin weise alt/Sicher heitshinweise am Anfang des Ka pitels beachten @ 101\ mod_1330611811687_7 8.docx @ 897943 @ @ 1
• Observe the safety instructions at the beginning of the section.
Pos: 71.66 /BA/Einste llungen/Mähwerke/Ea syCut/Verriegel ung einstellen Text EC R 280/320 CV / EC R 360 @ 91\mod_13261763460 08_78.docx @ 777147 @ @ 1
The locking (2) prevents during use that the side panel folds up and that foreign objects are
slung away. Therefore, it is very important to ensure before every use that the side panel (1) of
the machine is folded down and that the locking (2) is secured.
The side panel (2) must be adjusted in that way that
• the side panel (1) folds down when swivelling the machine from transport position to
working position and that it is secured by the locking (2)
• the side panel (1) slides independently from the locking when swivelling the machine from
working position to transport position and that the side panel is folded over to transport
position. Thus the transport height is reduced.
If this is not the case, the locking (2) must be set via the screw connection (3).
To do this:
• Loosen the screw connection (3)
• Readjust the locking in the oblong hole
• Tighten the screw connection (3)
Pos: 71.67 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
