Krone EasyCut B 1000 CV - Blade Screw Connection Procedure; Blade Quick-Fit Device Usage

Maintenance - Blade Changing
191
Pos: 99.11 /BA/W artung/Mähwerke/Messersc hraub / Messerschne llverschluss/Mess erschraubverschl uss Haltebolzen 14 mm @ 0\mod_ 1197267907375_78. docx @ 16425 @ 3 @ 1
19.1.2 Blade screw connection
Danger! - Insufficient thickness of material on the retaining bolts.
Effect: Danger to life or serious injuries.
• At every blade changing check the thickness of the holding bolts material.
• Damage or worn retaining bolts must always be replaced by sets on each cutting
disc/blade drum!
• The material thickness of the retaining bolts must not be less than 14 mm at the weakest
point.
EC-240-0
min. 14 mm
Fig. 123
Pos: 99.12 /BA/W artung/Mähwerke/Messersc hraub / Messerschne llverschluss/ Messerschnellversc hluss Haltebolzen 14 mm @ 0\mod_1197268087875_78.d ocx @ 16444 @ 3 @ 1
19.1.3 Blade Quick-Fit Device
Danger! - Insufficient thickness of material on the retaining bolts.
Effect: Danger to life or serious injuries.
• At every blade changing check the thickness of the holding bolts material.
• Damage or worn retaining bolts must always be replaced by sets on each cutting
disc/blade drum!
• The material thickness of the retaining bolts must not be less than 14 mm at the weakest
point.
• The material thickness of the leaf spring must not be less than 3 mm at the weakest point.
EC-239-0
min. 14 mm
Fig. 124
Pos: 99.13 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1